How to reset picture settings on a Fujitsu Zero Client DZ22-2 Monitor?
To correct a wrongly adjusted picture on your Fujitsu Monitor, press the MENU button to activate the Factory Recall function.
How to fix a Fujitsu Monitor with no screen display when the power indicator is off?
If there is no screen display and the power indicator does not light up on your Fujitsu Monitor, first check that the mains cable or LAN cable with Power over Ethernet (only on Zero Client DZ22-2) is properly connected. If you are using Power over Ethernet, ensure that sufficient power is available. Refer to the technical data for power requirements.
What to do if the indicator flashes red on a Fujitsu Zero Client DZ22-2 Monitor?
If the indicator flashes red on your Fujitsu Monitor, it could mean that there is no network cable connected to the Zero Client, or the network cable is faulty. Ensure the network cable is securely connected at both ends. If the problem persists, try using a different network cable to connect the Zero Client to the network.
How to troubleshoot a Fujitsu Zero Client DZ22-2 Monitor with no screen but the power indicator is on?
If there is no screen display but the power indicator is lit on your Fujitsu Monitor, first check if the Zero Client is in energy-saving mode by pressing any key on the Zero Client’s keyboard. If that doesn't work, try adjusting the brightness and/or contrast settings until a picture appears.
General| Brightness | 250 cd/m² |
|---|---|
| Contrast Ratio | 1000:1 |
| USB Ports | 4 x USB 2.0 |
| Aspect Ratio | 16:9 |
| Screen Size | 21.5 inches |
| Native Resolution | 1920 x 1080 |
| Video Inputs | 1 x DisplayPort, 1 x DVI-D |
Essential safety precautions for device operation and environment.
Covers power cable, safe transport, and cleaning guidelines.
Information on product compliance and environmentally sound disposal.
Procedures for unpacking the device and verifying the delivery contents.
Guide to setting up the device and creating an ergonomic workstation.
Steps for attaching the base and adjusting monitor height and tilt.
How to rotate the screen, use portrait mode, and mount with brackets.
Instructions for connecting necessary cables to the Zero Client.
Procedures for powering the device on and off, and logging out.
Information on power consumption modes and settings.
Logging into the system and initial user interaction.
Adjusting display parameters via OSD menu and control buttons.
To Next Page