Need help?Do you have a question about the Fukuda Denshi DS-8400 and is the answer not in the manual?
General| Number of Channels | 12 |
|---|---|
| Input Voltage | 100-240 VAC |
| Category | ECG |
| Paper Speed | 5, 10, 12.5, 25, 50 mm/s |
| Connectivity | LAN |
| Storage | Internal memory |
| Power Supply | AC power and battery |
| Operating Conditions | Temperature: 10°C to 40°C |
Information regarding safety precautions, meaning of symbols, and warnings attached to the unit.
Guidelines for safe operation of medical electrical equipment, including installation, storage, and usage.
Safety precautions when using the equipment with other medical devices like pacemakers and defibrillators.
General precautions for using the system, monitoring, and specific parameter measurements.
Guidelines and safety checks required for regular equipment maintenance and immediate maintenance actions.
Provides specifications for the main unit, including size, weight, environmental conditions, safety, and power supply.
Details the performance specifications of the DS-8400 system, including display, operation, sound pressure, and clock accuracy.
Identifies and describes the parts and functions of the DSC-8400 main unit's front, rear, right, and left sides.
Details the main CPU board's components and functions, including CPU, memory, power supply, and interfaces.
Lists spare parts for the DSC-8400 main unit, categorized by battery group, board ASSYs, and cables.
Step-by-step instructions for attaching the display unit to the main unit, including warnings and notes.
Procedure for installing the HR-800 Recorder Unit to the main unit, with detailed steps and illustrations.
Instructions for installing the HLX-801 telemetry transmitter module, including antenna and connection steps.
Describes procedures for software upgrade, including backup/restore and when backup is not needed.
Troubleshooting common ECG issues like lead off, low amplitude, artifacts, and pacing errors.
Troubleshooting respiration measurement issues such as CVA detected, range exceeded, and waveform display.
Troubleshooting common issues with invasive blood pressure measurement, including transducer errors and zeroing.
Troubleshooting SpO2 measurement issues like sensor attach, pulse search, motion artifact, and unit failure.
Troubleshooting NIBP issues such as cuff inflation, pump operation, measurement errors, and connection failures.
Troubleshooting temperature measurement errors like unknown sensor, disconnected probe, and unit failure.
Troubleshooting CO measurement issues like varying values, abnormal readings, and curve deformation.
Troubleshooting CO2 measurement issues such as sample line, sensor failure, calibration, and disconnection.
Troubleshooting telemeter issues such as data reception, impedance waveform, BP waveform, and HLX connection.
Troubleshooting Super Unit issues like system start failure, temperature range, analog unadjusted, and SD card errors.
Troubleshooting issues with the IB-8004 Input Box, such as system start failure and module disconnection.
Troubleshooting expansion module issues like system start failure, connection errors, and power supply.
Troubleshooting ventilator alarms and communication issues with the monitor and ventilator.
Troubleshooting multigas unit issues like failure, sample line, water trap, and patient classification.
Lists and describes daily check items, procedures, and criteria for cleanness, appearance, and operation.
Details periodic check items and procedures for preparation, cleaning, external appearance, power supply, and display/operation.
Step-by-step procedure for CO2 gas calibration, including messages and precautions.
To Next Page