Fukuda FRE-207 - User Manual

FRE-207
INSTRUCTIONS
from P.R.Engineering Ltd www.laser-level.co.uk Tel: 01246 269777
Thank you for purchasing the FRE-207 TRUE GRADE, Rotary laser level kit.
These Instructions are intended to explain the quick basics to operating this
equipment. Please read them in conjunction with the Manufacturer's User
Manual included in the kit. If you need any more help/advice or the
instrument requires calibration or repair, then please contact our Service Dept
on
tel 01246 269 777 or fax 01246 260 007. We would be pleased to help.
Power source:
This is a special battery pack located in the base of the laser. Remove & refit
via a central screw - finger tight (no tools required).
It contains 4pc x "sealed for life" Ni-MH type C, 4000mAh, 1.2V cells. Please
note that this battery pack can be charged either in or outside of the laser.
The Mains Charger (supplied) will charge most batteries in around 7 hours to
give around 20hrs of continuous use. It takes 4 to 5 charge/discharge cycles
1

Summary

Power Source Information

Mains Charger Operation

Laser Positioning Guidelines

Laser Controls Overview

Grading Functions

Setting Single Axis Slope

Sets a grade in the X axis only via keypad or remote.

Setting Y Axis Slope

Sets a grade in the Y axis only via keypad or remote.

Setting Dual Grade (X & Y Axes)

Sets grades for both X and Y axes simultaneously.

Automatic Drift System (ADS)

Remote Control and Detector

Remote Control Operation

Covers battery installation and functions of the remote control.

Laser Detector Usage

Explains detector setup, power, sounder, resolution, and usage.

Safety Precautions

General Advice and Care

Key Specifications

Fukuda FRE-207 Specifications

General

Type	Rotary Laser Level
Laser Wavelength	635 nm
Protection Class	IP54
Working Range	Up to 200m with detector
Laser Class	Class 2
Power Supply	4 x AA Batteries