WWW.FUNNMTB.COM
FULL ON HANDLEBAR 2024.01.30 / REV. 0
Attach the new handlebar onto the stem, but don’t fully tighten it yet to allow for alignment adjustments. Ensure it is
properly aligned and centered within the stem clamp.
3.
Once the new bar is in place, adjust its roll angle, which affects wrist
comfort and bike control. Then, tighten the stem's faceplate in a cross
pattern for even pressure distribution.
4.
Reattach the components you previously removed onto the new handlebar, ensuring they are positioned for optimal
comfort and accessibility.
5.
INSTALLATION AND USE
FULL ON HANDLEBAR
To Previous Page
Loading...
