Funn FULL ON HANDLEBAR User Manual

WWW.FUNNMTB.COM
FULL ON HANDLEBAR 2024.01.30 / REV. 0
INSTALLATION AND USE
FULL ON HANDLEBAR
． FULL ON Handlebar 1 PC
contents
tools required
Carefully detach any components attached to the old handlebars, such as shifters, brake levers, grips, and bar ends.1.
Loosen and then remove the stem faceplate. Following this,
remove the old handlebars from the stem.
2.
Thank you for choosing FUNN’s FULL ON handlebar for your mountain bike.
Please read these instructions thoroughly before attempting to install this item.
Following all fitting instructions in order is required for compliance with FUNN’s warranty policy.
． Hex keys
FUNN handlebars are designed to be cut down to fit your style, but when trimming carbon bars, special care is required, so
it's best to consult a professional.
For precise adjustments, follow the guide marks on the bar,
ensuring you don't cut below the inner-most mark for safety.
It's important to cut the same distance on both sides to
maintain balance. Remember, after cutting carbon bars, refrain
from using bar ends to ensure the integrity of your handlebars.
HANDLEBAR CUTTING
Handlebar installation

Funn FULL ON HANDLEBAR Specifications

General

Brand	Funn
Model	FULL ON HANDLEBAR
Category	Bicycle Accessories
Language	English