Funn UPTURN HANDLEBAR

To Next Page

WWW.FUNNMTB.COM

UPTURN HANDLEBAR 2024.01.30 / REV. 0

INSTALLATION AND USE

UPTURN HANDLEBAR

． UPTURN Handlebar 1 PC

contents

tools required

Carefully detach any components attached to the old handlebars, such as shifters, brake levers, grips, and bar ends.1.

Loosen and then remove the stem faceplate. Following this,

remove the old handlebars from the stem.

Thank you for choosing FUNN’s UPTURN handlebar for your mountain bike.

Please read these instructions thoroughly before attempting to install this item.

Following all ﬁtting instructions in order is required for compliance with FUNN’s warranty policy.

． Hex keys

FUNN handlebars are designed to be cut down to ﬁt your style, but when trimming carbon bars, special care is required, so

it's best to consult a professional.

For precise adjustments, follow the guide marks on the bar,

ensuring you don't cut below the inner-most mark for safety.

It's important to cut the same distance on both sides to

maintain balance. Remember, after cutting carbon bars, refrain

from using bar ends to ensure the integrity of your handlebars.

HANDLEBAR CUTTING

Handlebar installation

Need help?

Do you have a question about the Funn UPTURN HANDLEBAR and is the answer not in the manual?

Summary

Tools Required

Handlebar Cutting

Handlebar Installation Steps

Detach Old Components

Carefully detach all components from old handlebars, including shifters, brake levers, grips, and bar ends.

Remove Old Handlebar

Loosen and remove the stem faceplate, then remove the old handlebar from the stem.

Attach New Handlebar to Stem

Attach the new handlebar to the stem, ensuring alignment and centering, but do not fully tighten yet.

Adjust Roll Angle and Tighten

Adjust the new handlebar's roll angle for comfort and control, then tighten the stem faceplate evenly in a cross pattern.

Reattach Components

Reattach all previously removed components onto the new handlebar for optimal comfort and accessibility.