To Next PageTo Next Page
Need help?Do you have a question about the Funn MAMBA and is the answer not in the manual?
Remove the side cap using a 6mm hex key.
Secure axle with 8mm hex key, loosen axle nut with 8mm socket wrench. Note thread direction.
Locate and gently remove the inner seal from the axle bore using tweezers.
Insert M4 bolt into pedal body with 3mm hex key, then attach washer and M4 nut.
Tighten M4 bolt using 3mm hex key and 7mm wrench until bearing is extracted.
Secure pedal body in a vise, using a cloth to protect its surface.
Screw bushing remover into bushing, then pull to remove.
Position new bushing on press, tap with plastic hammer to install.
Grease interface, push new bearing into pedal by tightening side cap.
Identify left (lathed mark) and right axles, fit seals, and apply grease.
Insert axle, hold steady, tighten axle nut. Ensure smooth pedal body pivot.
Reattach side cap with 6mm hex key and check for smooth rotation and no side-to-side movement.
General| Brand | Funn |
|---|---|
| Model | MAMBA |
| Category | Bicycle Accessories |
| Language | English |
