WWW.FUNNMTB.COM
INSTALLATION AND USE
LEFT RIGHT
LEFT
RIGHT
Thank you for purchasing this set FUNNDAMENTAL PEDALS.
Please read these instructions thoroughly before attempting to install this item.
Proper installation is required for compliance with FUNN’s warranty policy.
2. Install the traction bolts and pins with the 3mm hex key and 4mm socket wrench, respectively.
You can fine tune the height of bolt with the 1mm washers. Do not use more than one washer per bolt.
． Hex key 2mm
． Hex key 8mm
． Hex key 3mm
． Socket wrench 4mm
． Pedals
． Traction pins
． Traction bolts
． Screw washers
1 SET
16 PCS
28 PCS
28 PCS
1. Identify the left and right hand side pedals. The left side pedal has a lathed mark on the axle head.
． Hex key 3mm
． Socket wrench 4mm
1 PC
1 PC
Socket wrench 4mm
Hex key 3mm
INSTALLATION AND USE
contents
tools required
PEDAL installation
FUNNDAMENTAL PEDALS 2024.04.23 / REV. 0
FUUNDAMENTAL PEDALS
To Next Page
Need help?
General
