Furrion FF23SW15A-BL - User Manual

Questions and Answers

B
Brooke RodriguezAug 2, 2025
Why is my Furrion Indoor Fireplace remote control not working?
- S
  smithjamesAug 2, 2025
  If the Furrion Indoor Fireplace remote control isn't working, first, replace the remote batteries, as they may be weak or defective. If that doesn't work, ensure you're operating the remote at a distance less than 20 feet from the front of the fireplace, pointing it at the control panel. Press the remote control buttons with an even motion and gentle pressure, as repeatedly pressing buttons in rapid succession may cause the remote to malfunction.
T
Thomas BrayAug 7, 2025
Why is my Furrion FF23SW15A-BL Indoor Fireplace not blowing warm air?
- D
  Dr. Dawn HartmanAug 7, 2025
  If your Furrion Indoor Fireplace doesn't blow warm air, it might be due to the cool-down cycle, which is normal operation for 30 seconds before shutting down. Alternatively, the thermostat setting may be preventing the fireplace from turning on. Adjust the temperature setting to ensure that the thermostat is set higher than the current room temperature.
C
Christopher HoffmanAug 12, 2025
What to do if my Furrion FF23SW15A-BL turns off automatically?
- N
  Nancy MeyerAug 13, 2025
  If the Furrion Indoor Fireplace turns off automatically, it could be because the slide out moves and activates the safety cut off. To prevent this, ensure you do not use the fireplace if the slide out is not in the fully extended position.
J
Janice RodriguezAug 17, 2025
What to do if my Furrion Indoor Fireplace display shows “EE”?
- J
  Jonathan HillAug 18, 2025
  If the Furrion Indoor Fireplace display shows “EE”, it indicates that the thermostat sensor is broken or disconnected. Unplug the fireplace and remove the back panel. Check that the thermostat is plugged into the main circuit board. If this does not solve the problem, contact customer service for a replacement thermostat sensor.
H
Heather SheltonAug 22, 2025
What does it mean when my Furrion FF23SW15A-BL Indoor Fireplace display shows “88”?
- B
  Brian HicksAug 22, 2025
  If the Furrion Indoor Fireplace display shows “88”, it means the manual reset overheat protection has triggered. Inspect the fireplace and check that the air inlets and outlets are not blocked, as this may cause overheating.
S
Sarah MasonAug 27, 2025
What to do if the RED LED is blinking and the blower motor doesn't start on my Furrion Indoor Fireplace?
- M
  Margaret McguireAug 28, 2025
  If the RED LED is blinking constantly and the blower motor does not start in your Furrion Indoor Fireplace, it indicates a proximity switch cut off. Ensure there are no obstructions within a minimum distance of 6 inches from the air vents. Press the Power button to restart the fireplace.