Furrion FF34SW15A-BL FF34SC15A-BL User Manual (English)

Questions and Answers:

T
Tina DawsonAug 7, 2025
Why is my Furrion FF34SW15A-BL FF34SC15A-BL Indoor Fireplace remote control not working?
- R
  rodriguezmichaelAug 7, 2025
  If the Furrion Indoor Fireplace remote control isn't working, first, replace the remote batteries, as they may be weak or defective. If that doesn't work, ensure you're operating the remote at a distance less than 20 feet from the front of the fireplace, pointing it at the control panel. Press the remote control buttons with an even motion and gentle pressure, as repeatedly pressing buttons in rapid succession may cause the remote to malfunction.
W
Wendy PopeAug 11, 2025
Why is my Furrion Indoor Fireplace not blowing warm air?
- K
  Kevin FosterAug 12, 2025
  If your Furrion Indoor Fireplace doesn't blow warm air, it might be due to the cool-down cycle, which is normal operation for 30 seconds before shutting down. Alternatively, the thermostat setting may be preventing the fireplace from turning on. Adjust the temperature setting to ensure that the thermostat is set higher than the current room temperature.
M
Melanie LeeAug 17, 2025
What to do if my Furrion FF34SW15A-BL FF34SC15A-BL turns off automatically?
- C
  Craig PetersAug 17, 2025
  If the Furrion Indoor Fireplace turns off automatically, it could be because the slide out moves and activates the safety cut off. To prevent this, ensure you do not use the fireplace if the slide out is not in the fully extended position.
O
owenbrittanyAug 22, 2025
What to do if my Furrion FF34SW15A-BL FF34SC15A-BL Indoor Fireplace display shows “EE”?
- J
  John HansenAug 22, 2025
  If the Furrion Indoor Fireplace display shows “EE”, it indicates that the thermostat sensor is broken or disconnected. Unplug the fireplace and remove the back panel. Check that the thermostat is plugged into the main circuit board. If this does not solve the problem, contact customer service for a replacement thermostat sensor.
E
Ellen GallegosAug 27, 2025
What does it mean when my Furrion Indoor Fireplace display shows “88”?
- E
  Edward GonzalezAug 27, 2025
  If the Furrion Indoor Fireplace display shows “88”, it means the manual reset overheat protection has triggered. Inspect the fireplace and check that the air inlets and outlets are not blocked, as this may cause overheating.
D
David MuellerSep 1, 2025
What to do if the RED LED is blinking and the blower motor doesn't start on my Furrion Indoor Fireplace?
- N
  nicole95Sep 1, 2025
  If the RED LED is blinking constantly and the blower motor does not start in your Furrion Indoor Fireplace, it indicates a proximity switch cut off. Ensure there are no obstructions within a minimum distance of 6 inches from the air vents. Press the Power button to restart the fireplace.

Furrion FF34SW15A-BL FF34SC15A-BL Specifications

General

Category	Indoor Fireplace
Fuel Type	Electric
Power	1500W
Heating Area	400 sq. ft.
Heating Coverage	400 sq. ft.
Remote Control	Yes
Thermostat	Yes
Timer	Yes
Color Options	Black
Product Type	Indoor Fireplace
Model Number	FF34SW15A-BL, FF34SC15A-BL
Voltage	120V
Flame Effect	Yes