Furrion FF40SW15A-BL - User Manual

Questions and Answers

N
Nina JohnsonAug 7, 2025
Why is my Furrion FF40SW15A-BL remote control not working?
- S
  Stephanie WintersAug 7, 2025
  If the Furrion Indoor Fireplace remote control isn't working, first, replace the remote batteries, as they may be weak or defective. If that doesn't work, ensure you're operating the remote at a distance less than 20 feet from the front of the fireplace, pointing it at the control panel. Press the remote control buttons with an even motion and gentle pressure, as repeatedly pressing buttons in rapid succession may cause the remote to malfunction.
J
Jennifer HinesAug 12, 2025
Why is my Furrion Indoor Fireplace not blowing warm air?
- T
  Tammie MendezAug 12, 2025
  If your Furrion Indoor Fireplace doesn't blow warm air, it might be due to the cool-down cycle, which is normal operation for 30 seconds before shutting down. Alternatively, the thermostat setting may be preventing the fireplace from turning on. Adjust the temperature setting to ensure that the thermostat is set higher than the current room temperature.
K
kevinwellsAug 17, 2025
What to do if my Furrion Indoor Fireplace turns off automatically?
- J
  John WolfAug 17, 2025
  If the Furrion Indoor Fireplace turns off automatically, it could be because the slide out moves and activates the safety cut off. To prevent this, ensure you do not use the fireplace if the slide out is not in the fully extended position.
M
Meghan KingAug 21, 2025
What to do if my Furrion Indoor Fireplace display shows “EE”?
- J
  Joyce CastroAug 22, 2025
  If the Furrion Indoor Fireplace display shows “EE”, it indicates that the thermostat sensor is broken or disconnected. Unplug the fireplace and remove the back panel. Check that the thermostat is plugged into the main circuit board. If this does not solve the problem, contact customer service for a replacement thermostat sensor.
C
Christopher McdanielAug 27, 2025
What does it mean when my Furrion Indoor Fireplace display shows “88”?
- B
  Brett NashAug 27, 2025
  If the Furrion Indoor Fireplace display shows “88”, it means the manual reset overheat protection has triggered. Inspect the fireplace and check that the air inlets and outlets are not blocked, as this may cause overheating.
S
Sandra ParrishSep 1, 2025
What to do if the RED LED is blinking and the blower motor doesn't start on my Furrion FF40SW15A-BL?
- L
  Leah SilvaSep 1, 2025
  If the RED LED is blinking constantly and the blower motor does not start in your Furrion Indoor Fireplace, it indicates a proximity switch cut off. Ensure there are no obstructions within a minimum distance of 6 inches from the air vents. Press the Power button to restart the fireplace.