Why is my Furrion Indoor Fireplace not blowing warm air?
If your Furrion Indoor Fireplace isn't blowing warm air, it might be due to a normal cool-down cycle, which lasts for 30 seconds before shutting down. Alternatively, the thermostat setting may be lower than the current room temperature. Try adjusting the temperature setting higher than the room temperature.
What to do if my Furrion FF26S15A-BL Indoor Fireplace turns off automatically?
If your Furrion Indoor Fireplace turns off automatically, it may be due to the slide-out not being in the fully extended position, which activates the safety cut-off. Ensure the slide-out is fully extended before using the fireplace.
What to do if the RED LED is blinking constantly and the blower motor does not start on Furrion Indoor Fireplace?
If the RED LED on your Furrion Indoor Fireplace is blinking constantly and the blower motor won't start, it may be due to the proximity switch being cut off. Make sure there are no obstructions within 6 inches of the air vents. Then, press the Power button to restart the fireplace.
How to fix Furrion Indoor Fireplace displaying “ ”?
If the display of your Furrion Indoor Fireplace shows “ ”, it could be due to a broken or disconnected thermostat sensor. Unplug the fireplace, remove the back panel, and check that the thermostat is plugged into the main circuit board. If the issue persists, contact customer service for a replacement thermostat sensor. It may also be that the manual reset overheat protection has triggered. Inspect the fireplace and check that the air inlets and outlets are not blocked as this may cause overheating.
Why is my Furrion Indoor Fireplace remote control not working?
If your Furrion Indoor Fireplace remote control isn't working, first replace the batteries. If that doesn't solve the issue, ensure you're within 20 feet of the fireplace and pointing the remote at the control panel. Also, press the buttons with a smooth, gentle motion, as rapidly pressing them can cause malfunctions.
What does it mean if my Furrion Indoor Fireplace display shows blank symbols?
If the display of your Furrion Indoor Fireplace shows “ ”, it could be due to a broken or disconnected thermostat sensor. Unplug the fireplace, remove the back panel, and check if the thermostat is plugged into the main circuit board. Another possible cause is that the manual reset overheat protection has been triggered. Inspect the fireplace to ensure that the air inlets and outlets are not blocked, as this can lead to overheating.
General| Model Number | FF26S15A-BL |
|---|---|
| Type | Electric Fireplace |
| Style | Wall Mount |
| Heat Output | 5100 BTU |
| Power Source | Electric |
| Voltage | 120V |
| Frequency | 60Hz |
| Wattage | 1500W |
| Heating Area | 400 sq. ft. |
| Color | Black |
| Remote Control | Yes |
| Thermostat | Yes |
| Timer | Yes |
| Overheat Protection | Yes |
| Installation | Wall Mounted |
To Next Page
