5
13
/16"
(148 mm)
RV Wall
Vertical Floor Ducting - Top View
9"
(229 mm)
Floor Ducting Area
Installing the Duct Collars
1. Remove the knockout plate(s) from the desired outlet(s).
Keep all other knockout plates in place if not used.
Knockout Plate
2. Install the duct adapter (provided) by inserting the flange
over the casing hole and turning the duct adapter 90° to
lock the tab into the casing slot.
3. Securely attach ducting to the duct adapter.
NOTE: If an unexpected knockout is removed accidentally,
consult Furrion or Furrion authorized dealer to purchase the
cover plates.
INSTALLATION
Installation of this appliance must be made in accordance
with the written instructions provided in this manual.
● This furnace shall be installed so the electrical
components are protected from water.
● This furnace is designed and certified for propane gas
use only. Do not attempt to convert to natural gas.
● Gas supply pressure for purposes of input adjustment:
minimum 11" W.C., maximum 13" W.C.
● The maximum wall thickness for installing the furnace is
2". Do not exceed the maximum wall thickness.
● The tubes supplied with the furnace accommodates an
installation 0 - 2". If greater than 2", then special tubes
must be purchased.
The installation must conform with local codes and
regulations. In the absence of such codes, refer to the latest
edition of:
In the U.S.A.:
1. Standard for Recreational Vehicles NFPA 1192.
2. National Fuel Gas Code ANSI Z223.1/NFPA 54.
3. Furnace must be electrically grounded in accordance
with the latest edition of the National Electrical Code
NFPA 70.
In Canada::
1. Standard CSA Z240.0.2-08 Recreational Vehicles.
2. CSA Standard Z240.6.2-08 C22.2 NO 148-08 Electrical
Requirements for Recreational Vehicles.
3. Standard Z240.4.2-08 Installation Requirements for
Propane Appliances and Equipment in Recreational
Vehicles.
4. CAN/CGA-B149 Installation Codes.
5. Any applicable local codes and regulations.
WARNING
Do not install screens over the vent for any reason. Screens
will become restricted and cause unsafe furnace operation.
Accessories are being marketed for RV products which we
do not recommend. For your safety, only factory authorized
parts are to be used on your furnace.
WARNING
Do not alter, cut or otherwise modify the vent tubes
as supplied with the furnace. Doing so could result in
inadequate intake of air combustion or improper exhaust
venting.
There are three (3) methods described below for installing
the furnace.
English
- 8 -
To Next Page
Loading...