3-10
Item Description Settings Default Setting
Fix Mode Choose position fixing method: 2D
(three satellites in view), 2D/3D (three
or four satellites in view whichever is
greater).
2D, 2D/3D 2D/3D
Cold Start Clears the Almanac to receive the latest
Almanac.
No, Yes No
WAAS setup (requires GPS receiver GP-320B)
Press the WAAS SETUP soft key to show the WAAS SETUP display.
Contents of WAAS SETUP menu
Item Description Settings Default Setting
WAAS Mode Select ON to use the WAAS mode. On, Off Off
WAAS
Search
WAAS satellite can be searched
automatically or manually. For manual
search, enter appropriate WAAS satellite
number.
Auto, Manual Auto
WAAS Alarm When the WAAS signal is lost, the
audible alarm sounds with the visual
message “NO WAAS SIGNAL.”
On: Alarm continues to sound until the
WAAS positioning mode is available
again or the alarm is recognized by key
operation.
Off: Alarm sounds three times.
On, Off Off
Corrections
Data
Selects the type of message for WAAS
correction. Use “00” (operational status)
in North America; “02” in other locations.
00 to 27, 99 02
39. After you have finished setting up the GPS receiver, it’s now time to set up external
equipment. Press the NEXT soft key to show the GPS/PORT menu. It is only necessary
to set up ports which you are going to use; skip unnecessary steps. If you do not have
external equipment connected to the NavNet, press the NEXT key several times to
show the “FINISH AND EXIT INSTALLATION WIZARD” screen and then push the
ENTER knob to finish.
OUTPUT FORMAT NMEA0183
Ver 2.0
LAT/LON FORMAT DD'MM.MMM'
OUTPUT DESTINATION NO
Installation wizard, GPS/PORT setup
To Next Page
Loading...
