What to do if nothing appears on the Furuno 1715 Marine Radar display?
If nothing is showing on the display, the battery may be discharged, so check the battery. Also, check if the fuse has blown.
What to do if the Furuno 1715 display freezes?
If the display freezes, press the [POWER/BRILL] key for about five seconds to turn off the power, and then turn it on again.
What to do if neither noise or targets appear on Furuno Marine Radar?
If neither noise nor targets appear, but characters and markers do, try adjusting the gain, A/C SEA, and A/C RAIN. Also, check the antenna cable for any damage.
How to fix Furuno Marine Radar when the control panel does not light?
If the control panel does not light, adjust the PANEL DIMMER on page 1 of the system menu.
How to fix poor display contrast on Furuno 1715 Marine Radar?
To improve poor display contrast, try adjusting the LCD contrast. (See page 4.)
What to do if nothing happens when a key is pressed on Furuno 1715?
If nothing happens when you press a key, the key may be faulty. Contact your dealer.
Describes the function and block diagram of the display unit.
Explains the function and block diagram of the scanner unit.
Instructions for upgrading the unit's program via PC.
Lists error messages and their meanings related to heading/bearing pulses.
A table to help identify defective PCBs or blocks based on symptoms.
Instructions for performing self-tests on the display unit (ROM, RAM, NMEA, Panel, GPS).
General| Brand | Furuno |
|---|---|
| Model | 1715 |
| Category | Marine Radar |
| Language | English |
To Next Page
