1. DESCRIPTION OF OPERATION
1-46
1.38 Waypoint Marker
The waypoint marker shows the location of the destination waypoint set on a naviga-
tion plotter. The heading signal or course data are required. You can turn on/off the
waypoint marker as follows:
Waypoint marker
1. Press the MENU key to open the menu.
2. Use the Cursorpad (S or T) to select [Others] and press the ENTER key.
3. Use the Cursorpad (S or T) to select [WPT Mark] and press the ENTER key.
WPT Mark options
4. Use the Cursorpad (S or T) to select [Off] or [On] then press the ENTER key.
5. Press the MENU key to close the menu.
1.39 Alarm Message
The alarm status window shows all currently violated alarms.
Note: The alarm status window is not automatically displayed when an alarm occurs.
1. Press the MENU key to open the menu.
2. Use the Cursorpad (S or T) to select [Alarm] and press the ENTER key.
+
Waypoint
marker
To Next Page
Loading...
