1. INSTALLATION AND WIRING
9
4. Apply adhesive around the base of the four stud bolts.
5. Set the insulation sheet (supplied) to the four stud bolts.
6. Hoist the antenna unit to the installation location, using two belt slings.
Note: When you hoist the antenna unit. keep in mind the following points:
Stud bolt
Adhesive
Vent hole:
Do NOT cover this hole.
Adhesive
Stud bolt
Do not fasten stud bolts tightly after
the bolts contact with the bottom of
the threaded holes.
If the bolts are fastened excessively, the
chassis bottom may be damaged which
can result in malfunction.
The projected bolt length after the bolts
contact with the bottom of the threaded
holes is approx. 50 mm. This data is for
reference purpose only.
NOTICE
Adhesive
Stud bolt
Insulation sheet
To Next Page
Loading...
