R
Robert MartinezAug 7, 2025
Why do echoes not appear on my Furuno DRS2D-NXT Radar, or why are they weak?
- JJason LynchAug 8, 2025
If transmission starts but echoes do not appear or weak echoes occur, check the settings of GAIN/SEA/RAIN.
To Next PageTo Next PageWhy do echoes not appear on my Furuno DRS2D-NXT Radar, or why are they weak?
If transmission starts but echoes do not appear or weak echoes occur, check the settings of GAIN/SEA/RAIN.
What to do if marks and characters appear on the Furuno DRS2D-NXT Radar display, but echoes do not appear?
If marks and characters appear on the display, but echoes do not appear, check that the Cable Assembly is fastened.
What to do if the Furuno DRS2D-NXT appears and disappears, or keeps rebooting when the transmission is started?
If the radar appears on the multi function display device, but disappears when the transmission started or continue rebooting, check the power voltage is sufficient.
What to do if the Furuno DRS2D-NXT type does not appear on the multi function display device?
If the radar type does not appear on the multi function display device: * Check if the Cable Assembly is connected to the power source and the power source is on. * Check the power cable for damage. * Check if the fuse has blown. * Check the voltage of ship’s main. * Check the software version of the multi function display device.
What to do if the Furuno Radar type appears on the multi function display device, but the radar display does not appear or transmission does not start?
If the radar type appears on the multi function display device, but the radar display does not appear or transmission does not start, check the software version of multi function display device.
What to do if there is too much interference on my Furuno DRS2D-NXT?
If you are experiencing too much interference, try the following: * Turn the interference rejector on. * Turn the transmission on/off. * Change the transmission channel.
What to do if the Furuno DRS2D-NXT Radar picture does not change when I change the range?
If you change the range, but the radar picture does not change, try to zoom the radar display in or out. Alternatively, turn the power off and on.
General| Type | Solid-state Doppler Radar |
|---|---|
| Beamwidth (Vertical) | 25° |
| IP Rating | IP56 |
| Frequency | 9.4 GHz (X-band) |
| Range | Up to 72 nm |
| Display | Furuno TZtouch2 or TZtouch3 |
| Supply/Operating Voltage | 12-24 VDC |
