1. INSTALLATION
6
• For waterproofing, wrap the junction of the connectors with self-bonding tape
and vinyl tape.
5. Insert a fuse in the fuse holder on the cable, referring to the instructions “HOW TO
ATTACH THE FUSE” (C32-01604-**), supplied with the cable. Attach the supplied
fuse rating label (5A) on the fuse holder cover.
6. Connect the LAN connector of the cable to the LAN port of FR-10/12, TZTL12F/
TZTL15F/TZT2BB, TZT9F/TZT12F/TZT16F/TZT19F, or the Ethernet Hub. Do not
connect to the onboard LAN.
Self-bonding tape
1) Wind one layer of the self-bonding tape
around the connector joint.
2) Change the winding direction and wind
one layer of the self-bonding tape again.
Self-bonding tape
3) Wind one layer of the vinyl tape over the
self-bonding tape.
Vinyl tape
4) Change the winding direction and
wind one layer of vinyl tape again.
Vinyl tape
Cable assy.
LAN connector
Ethernet Hub
OR
䠢䠮
-10/12
TZTL12F/TZTL15F/TZT2BB,
TZT9F/TZT12F/TZT16F/TZT19F
OR
To Next Page
Loading...