Furuno DRS6A-NXT - Initial Setup for TZT9;TZT14;TZTBB

2. INITIAL SETUP
16
2.1 Initial Setup for TZT9/TZT14/TZTBB
1. Press the
Home
key (or tap the
Home
icon).
2. Select [Menu] on the menu icon bar to open the main menu.
3. Select [Radar].
4. Select [Radar Source] on the [Menu Radar] sub menus, then select the radar type
connected.
Note:
If the antenna unit is connect-
ed but does not appear in the [Ra-
dar Source] list, close the list and
open it again. The name of the an-
tenna unit should appear with a
check mark, as in the example to
the right.
5. Drag the [Menu Radar] sub menus
to find the menu item [Radar Initial
Setup].
6. Set the items referring to the table shown below
Menu Radar (Radar Initial Setup)
Menu item Description
[Antenna Rotation] Select the antenna rotation speed.
[Antenna Heading Align] See "How to align the antenna heading" on page 17.
[Main Bang Suppression] If main bang appears at the screen center, slide the circle
icon, while watching the radar echo on the left-side of the
display, until the main bang disappears.
[Enable Sector Blanking]/
[Enable Sector Blanking2]
Up to two sectors may be selected for blanking (no trans-
mission). Select [ON] to enable this feature. Set the start
and end angles (0° to 359°).
[Antenna Height] Select the height of the antenna above the waterline.
RDxxxxxx - DR
S
6A-NX
T
RDxxxxxx - DR
S6
A-NX
T
Display example
Title