Furuno FAR-2238S - 3.11 How to Assign a Preset Name to TT Targets (B; W-type only); 3.11.1 How to activate the preset name function; 3.11.2 How to setup preset names

3. TARGET TRACKING (TT)
3-14
3.11 How to Assign a Preset Name to TT Targets (B/
W-type only)
You can assign a preset name to TT targets, which is displayed alongside the TT num-
ber in the target list.
3.11.1 How to activate the preset name function
1. Open the menu.
2. Select [5 TT•AIS].
3. Select [6 TT].
4. Select [5 TARGET NAME FUNCTION].
5. Select [ON], then press the ENTER MARK key.
3.11.2 How to setup preset names
1. Open the menu.
2. Select [5 TT•AIS].
3. Select [6 TT].
4. Select [6 TARGET
NAME PRESETS].
5. Select the appropriate
preset.
The software keyboard
appears.
6. Referring to
section 1.5.2, set the
preset name. A maximum of eight characters may be used for the preset name.
Note: If the assigned name is more than six characters in length, only the fist six
characters of the name appear in the target list (see section 3.10).
7. Close the menu.
Select [0 NEXT] to
show page 2.