Furuno FCV-587 - Page 23

1. OPERATION
16
Bottom
1) Set [Bottom] to [On] and press the EN-
TER key.
2) Select [From] and
press the ENTER key.
3) Set the starting depth
and press the ENTER
key.
4) Select [Span] and
press the ENTER key.
5) Set the width of the
alarm and press the
ENTER key.
10. Press the MENU/ESC
key to show the [FIsh School] setting win-
dow.
11. Select [Alarm] and press the ENTER key.
12. Select [On] and press the ENTER key.
Note 1: To disable an alarm, select [Off] at
step 12 in the above procedure.
Note 2: The default alarm settings can be re-
stored. Open the [Fish Alarm] setting window,
select [Reset?], press the ENTER key, select
[Yes] and press the ENTER key.
Navigation alarms
Do the following to set the navigation alarms
(speed alarm and arrival alarm).
1. Open the menu, select [Alarm] and press
the ENTER key.
2. Select [Speed] or [Arrival] and press the
ENTER key.
3. Do one of the following two procedures
according to the item selected at step 2.
Speed
1) Select [Speed] and press the ENTER
key.
2) Select [Inside] or [Outside] as applica-
ble and press the ENTER key.
3) Select [From Speed]
and press the ENTER
key.
4) Enter the starting
speed and press the ENTER key.
5) Select [Speed Span]
and press the EN-
TER key.
6) Enter the width of the
alarm and press the ENTER key.
Arrival
1) Select [Arrival] and press the ENTER
key.
2) Select [Inside] or [Outside] as applica-
ble and press the ENTER key.
3) Select [Radius] and
press the ENTER key.
4) Enter the alarm radius
and press the ENTER
key.
To disable the alarm, select [Off] at 2) of
step 3.
*
*
* Settable when alarm is activated.