Furuno FMD-3100 - Route Plan Checklist

Voyage number from to Date
YES
NO
N/A
ENC Charts updated with latest AIO CD/DVD/download?
ENC Charts updated with latest temporary and preliminary notices from e.g. NAVTEX
Viewing Dates: use [Single Date] or [Date Range] with correct start and end date for
planning of your up-coming voyage
Is the route prepared using safe settings for Draught, Safety Contour and Depth
Contours in compliance with company Under Keel Clearance policy and with due
regard to Squat Effect
(Including Trim & Heel)?
Safety Contour Planning: m
Is the route prepared in compliance with company Under Keel Clearance policy and
with due regard to Squat Effect (Including Trim & Heel)?
UKC Limit: m
Is the route prepared with vessel’s correct draught?
XTD Limits set to a minimum of 2 nautical miles at open sea (If possible)?
Calculated ETA in route planning tool using present departure date?
User Chart created and/or updated for the voyage?
Is relevant Parallel Index prepared?
It is recommended to check to Route Plan using IMO All. When the Route
Plan check is completed, the operator should re-select the Company
approved Chart Display with all relevant settings
.
Is the Route Plan checked both visually and using the ECDIS’s automatic check
function? – as recommended?
Is the Route Plan rectified for Safety Contour alerts? – as recommended?
Route plan checked together with User Chart using voyage specific Safety
Contour?
Has the Route Plan’s Check Result been read and evaluated?
Print Passage Plan Report?
Alert Parameters selected for planning this route:
Selected
Off
Safety Contour
Navigational Hazard
Areas To be avoided
User Chart Danger
Traffic Separation Zone
Inshore Traffic Zone
Restricted Area
Caution area
Offshore Production Area
Military Practice Area
Seaplane Landing Area
Submarine Transit Lane
Anchorage Area
Marine Farm / Aquaculture Area
PSSA Area
No Vector Chart?
UKC Limit?
Sounding UKC Limit?
Non-official ENC?
Not Up-to-date?
Permit Expired?
Navigation Officer of the watch Route Plan checked by Master
(If applicable)
45
© FURUNO MARITIME TRAINING a part of Furuno Denma
rk A/S 2016. All rights reserved.
No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical,
photocopying, recording or otherwise,
without the prior written permission ofFMT.
Z:\Training Courses\TST FMD\TST FMD {out of house}\03.17\04 Trainees Manual\Furuno ECDIS Trainee course manual version 4.0