7.1 Output power
7-5
9. Set TX POWER ADJ line. Rotate the knob or use numeric keys to enter power data.
Press PTT switch for transmission. Measure the T/R output power on power meter
or readout Vc and Ic then calculate output power. And then, change power data.
Tx signal frequency is modulated by 1785Hz tone signal that is not concern TX
MODE setting.
10. Repeat from step 6 for another operating frequency.
11. Move the cursor over SAVE TX POWER and press [ENT] to save the data.
12. Select YES and press [ENT].
Factory default setting
To select factory default;
1. Move the cursor over ERASE TX POWER and press [ENT].
2. Select YES and press [ENT].
To Next Page
Loading...
