1. INSTALLATION
2
•
Rubber foot which absorb vibration (supplied) maybe attached as below if vibration is a
problem.
45 5mm
Aline with edge
of hanger.
Rubber foot
TM-166 No.18 black
Mounting procedure
Follow the procedure below to mount the display unit on a tabletop or the overhead.
Tabletop, overhead mounting
1. Fix the hanger by four tapping screws 5 X 16.
2. Screw knob bolts in display unit, set it to hanger, and tighten knob bolts.
3. Attach hard cover to protect LCD.
WARNING
Tabletop, overhead mounting of display unit
To Next Page
Loading...
