11-1
11. OTHER SETTINGS/FUNCTIONS
This chapter covers settings, functions and menus not previously described in this
manual.
11.1 [General] Menu
To show the [General] menu, tap the [Home] icon => [Settings] => [General].
[Date and Time] sub-menu
• [UTC]: Select [ON] to use UTC time, [OFF] to use the internal clock.
• [Custom]: Sets the UTC time offset (This item is available when [UTC] is set to
[OFF]).
• [Daylight Saving Time]: Select ON to use daylight saving time, OFF to use normal
time. (This item is available when [UTC] is set to [OFF].)
• [Time Format]: Selects the format in which to display the time.
• [Date Format]: Select the format in which to display the date.
Tips (Quick Guide) sub-menu
Select [ON] to show the Quick Guide at startup, [OFF] to hide the Quick Guide.
Factory Defaults sub-menu
Resets the [General] menu to factory default settings.
A confirmation message appears when you tap [Reset to Factory Defaults]. Tap [Yes]
to reset the menu, tap [No] to cancel.
11.2 [Units] Menu
To show the [Units] menu, tap the [Home] icon => [Settings] => [Units].
[Units] sub-menu
Tap an item to show the available units of measurement, then tap the desired unit.
[Fuel] sub-menu
Tap the desired unit or measurement for fuel consumption.
[Formats and References] sub-menu
• [Bearing Display]: Sets the reference for bearing display; select [M] for magnetic, [T]
for true.
• [Magnetic Variation]: Sets the calculation reference for magnetic variation. Select
[Internal] to use the internal processor, or select [External] to use connected equip-
ment for the calculation.
• [True Wind Calculation Reference]: Sets the reference for true wind speed calcula-
tion. Select [Ground] or [Surface] (water surface) as required.
• [Position Format]: Sets the format for the display of position (latitude/longitude).
To Next Page
Loading...
