20
Power source
The power source is a 12-24 VDC battery. Be sure the power cable is tightly fastened to the power
source and the polarity (plus and minus) is correct. Connect the white lead to the positive terminal
(+) and the black lead to the negative terminal (-).
Transducer
Connect the transducer to XDR port on the rear of the display unit. If the optional speed/water tem-
perature sensor is connected, connect the transducer with the optional cable 02S4147 (Code No.
000-141-082).
How to connect transducer and sensor with optional cable 02S4147
Connect to XDR port on display unit
MJ-A10SPF
MJ-A6SRMD
MJ-A10SRMD
Connection Cable
Type: 02S4147
Code No.: 000-141-082
Connect water temperature
sensor, speed/water temperature
sensor.
Connect transducer.
To Next Page
Loading...
