Furuno SCX-21 User Manual

OPERATOR'S MANUAL
www.furuno.com
SC Setting Tool
Applicable model
SC-33
SCX-20
SCX-21

Furuno SCX-21 Specifications

General

Type	Satellite Compass
Update Rate	10 Hz
Operating Temperature	-25°C to +55°C
Frequency	L1 (1575.42 MHz)
GNSS	GPS, GLONASS, GALILEO, BEIDOU
Power Supply	12-24 VDC
Interfaces	NMEA 0183, NMEA 2000

Summary

Operational Overview

Minimum PC Requirements

Specifies the minimum hardware and software needed to run the SC setting tool.

Connection with a PC

Provides an overview of connecting the PC to the SATELLITE COMPASS.

NMEA2000 Network Connection (SC-33/SCX-20)

CAN-USB Converter and Drop Cable

NMEA0183 Serial Connection (SCX-21)

How to Install the SC Setting Tool

Step-by-step guide for installing the SC setting software.

How to Start and Close the SC Setting Tool

Outlines the process for starting and closing the SC setting tool.

How to Connect a PC to the SATELLITE COMPASS

Specific steps for establishing PC connection to the SATELLITE COMPASS.

How to Close the SC Setting Tool

Procedures for properly exiting the SC setting tool application.

How to Setup the Menu

GNSS Setup Tab Configuration

Details how to configure GNSS settings, including satellite disabling and elevation masks.

Sensor Setup Tab Configuration

Guides on setting up sensor offsets and ship information for accurate readings.

PGN Setup Tab (SC-33/SCX-20)

Covers enabling/disabling PGN output and setting transmission rates.

Port Setup Tab (SCX-21)

Simple Diagnostic Test

Advanced Diagnostic Test (SCX-21)

System Information Tab (SCX-20/SCX-21)

Restart and Reset Options

Debug Monitor Tab (SCX-20/SCX-21)