12
SETUP NMEA/DGPS PORT 2 menu
description
This menu should be set according to the
specifications of the equipment connected to
connectors PORT 1 (NMEA) and PORT 2
(DGPS) at the rear of the display unit. The
menu can be displayed by pressing the
[MENU] key followed by the soft keys CON-
FIGURATION and SETUP NMEA PORT 2.
For detailed information, see the installation
manual.
FORMAT- WITH NEW RTCM(OUTPUT)
Selects data format of connected equipment;
NMEA0183 version 1.5, version 2.0,
RTVM104 (EXTRN), RTCM104 (INTRN) or
RTCM104 (OUTPUT). RTCM104 (INTRN) is
for "D" versions only. The default setting
for non-"D" versions is RTCM104 (EXTRN).
The procedure for setting LAT/LON FORMAT
is similar to those for PORT 1. Note that
you cannot setup data sentences when you
select RTCM104 (INTRN) as the format. (A
level converter (IF-1432) maybe required
when using NMEA0183 format from this port.)
LAT/LON FORMAT (GGA only)
Selects the seconds of latitude and longitude
positions in hundredths, thousandths or ten
thousandths of a degree.
UPLOAD/DOWNLOAD DATA menu
This menu allows you to upload waypoint and
route data to a PC or download the same
data from a PC, via the DGPS connector at
the back of display unit. The menu can be
displayed by pressing the [MENU] key fol-
lowed by the soft keys CONFIGURATION
and UPLOAD/DOWNLOAD DATA. For de-
tailed information, see the installation manual.
See previous pages for Memory Card info.
DWNLOAD
UPLOAD
DGPS 3D
DOWNLOAD WPT/RTE TO PC
UPLOAD WPT/RTE FROM PC
RETURN
SAVE DATA TO MEMORY CARD
LOAD DATA FROM MEMORY CARD
upload/download menu
Display unit, rear view
Set communication software on the PC as
follows:
Baud Rate: 4800 bps
Character Length: 8 bit
Stop bit: 1 bit
Parity: None
X Control: XON/XOFF
The following data can be downloaded/up-
loaded between a personal computer and this
equipment.
•Waypoint data (In alphanumeric order)
•Route data (In order of route number)
•End of sentence
Note 1: There are two kinds of data for route
data: route data and route comment data.
Note 2: DGPS position fix is not available
when uploading or downloading data.
To Next Page
Loading...
