Furuno NAVNET 3D MFDBB - Selecting a Display

Chapter 1: Operational Overview
1-6
1.5 Selecting a Display
Use the DISP key and ROTOkey to select a display. The displays available depend
on the equipment you have in your NavNet system. In a later chapter you will learn
how to customize the display selection to suit your needs and system configuration.
1. Press the DISP key to show the display selection window. (The labels in the illus-
tration below do not appear on the actual display.)
Display selection window
2. Rotate the Rotary Knob to place the display desired inside the on-screen display
unit.
3. Push the Rotary Knob to confirm selection.
Switching Active Display in Combination Displays
Use the CTRL key to switch active display in combination displays. Each time the key
is operated the active display is switched and the active display is circumscribed with
a yellow square.
FISH FINDER DISPLAY
(under development)
RADAR
DISPLAY
CHART PLOTTER DISPLAY
PIP DISPLAY