Chapter 1: Operational Overview
1-4
1.2 Inserting, Removing a Chart Card
Before turning on the power, insert the chart card for your area in the card drive. Your
multi function display can read C-MAP NT MAX/MAX2, Mapmedia and S52 cards.
Inserting a Chart Card
1. Open the card drive lid at the lower left side of Control Unit MCU-001, or the lower
right side of the Display Control Unit DCU12.
2. Insert chart card label side up in one of the slots. It will go in only if oriented and
inserted correctly.
3. Close the lid. You will hear a click when the lid is correctly closed.
Removing a Chart Card
1. Open the card drive lid.
2. Push in the card. The card will pop half way out. Pull out the card.
3. Close the lid. You will hear a click when the lid is correctly closed.
Precautions with Chart Cards
• Do not remove a card while the chart is being drawn. This can cause the equipment
to freeze.
• Do not insert or remove a card while the power is on. This can cause the equipment
to freeze.
• Keep the lid closed at all times to keep foreign material and water out of the card
drive.
• Remove, insert and store the card with care. Rough handling can damage the card
and destroy its contents.
DCU12MCU-001
Card drive
To Next Page
Loading...
