Furuno PG-700 - How to Turn on the PG-700

2. OPERATION
14
2.2 How to Turn on the PG-700
The unit has no power switch. Supply the +12 VDC power via the optional junction box FI-5002 or
FURUNO CAN bus device. When power is received by the sensor, the unit will automatically
check ROM and RAM status. After this, the lamps light as shown below:
Note: If there is a problem with the ROM and/or RAM, the CALIB and CHECK lamps turn off, and
the STATUS lamp flashes red. Contact your dealer.
: OFF
: ON (green)
CALIB STATUS CHECK
CALIB STATUS CHECK
CALIB STATUS CHECK
CALIB STATUS CHECK
: ON (red/green)
CALIB STATUS CHECK
Normal display
CALIB STATUS CHECK
: Flashing (green)
Angular velocity sensor initialization
(Approx. two minutes)