1. HOW TO INSTALL THE EQUIPMENT
12
1.5 Input/Output Data List
This unit uses the following input/output data
PGN: Parameter Group Number. Equivalent to NMEA0183 sentence.
*1: Data can be output at an interval of 25ms and over (5ms steps) according to the request from
another device.
*2: PGN registered to Furuno Electric Co. Ltd.
Input/
Output
Specification Remark
Input ISO request (PGN: 059904) PGN send request
Address claim (PGN: 060928) Address request
Self Test Group Function (PGN: 061184) Self test request
Memory Clear Group Function (PGN: 126720) Corresponding to clear all
Reset Group Function (PGN: 126720) Corresponding to reset all
NMEA-Request Group Function (PGN: 126208) Output period setting
NMEA-Command Group Function (PGN: 126208)
+ (PGN: 130818, #4)
+ (PGN: 065283, #4, #5, #6, #7)
Change setting
Input bearing adjustment
Specific setting
Output
Vessel Heading (PGN: 127250)*1
Magnetic Compass Status (PGN: 065284)*2
Regular output.
100 ms (default)
1sec.
ISO Acknowledgement (PGN: 059392)
ISO Request (PGN: 059904)
Address Claim (PGN: 060928)
NMEA Acknowledge (PGN: 126208)
PGN List (PGN: 126464)
Product Information (PGN: 126996)
Self Test Report (PGN: 130816)*2
Heading & Attitude Sensor Control Status (PGN:
130818)*2
Unit Division Code (PGN: 130822)*2
Browser Control Status (PGN: 130823)*2
Magnetic Compass Control Status (PGN: 065283)*2
Rate Gyro Data (PGN: 065285) *1*2
GMM Message (PGN: 126720, #4=4)*2
Irregular output. (Send only
when there is a request during
startup and changes). Dis-
plays each setting.
To Next Page
