Furuno TZTL12F - Retrofit Kit for TZTL12 F (Option) and Front Fixing Panel Kit for TZTL15 F (Option)

1. MOUNTING
1-3
7. Fasten each wing bolt so that the protector for screw touches the mounting panel.
8. Fasten the wing nuts tightly.
1.3 Retrofit Kit for TZTL12F (option) and Front Fixing
Panel Kit for TZTL15F (option)
When upgrading to the TZTL12F or front-mounting the TZTL15F, use the kit which
matches your old equipment. (Refer to the table below for details.)
1. Prepare a cutout in the mounting location using the template (supplied) for the
TZTL12F or TZTL15F.
2. Place the NavNet TZtouch2 unit
face-down on a a soft, clean surface.
3. Set the F Mount Panel to the NavNet
TZtouch2 unit, then using the hex bolts
supplied with the flushmount bracket
installation materials (CP19-01800/
CP19-01900), fix the F Mount Panel to
the unit.
Optional kit Code No. Contains Remarks
OP19-15 001-337-430 F Mount Panel A (Code
No.: 100-397-090-10),
520 SUS304, 4 pcs.
(Code No.: 001-336-820)
For NavNet/NavNet Vx2 displays.
(RDP-138/139/149/151)
(For TZTL12F)
OP19-16 001-337-440 F Mount Panel B (Code
No.: 100-397-100-10),
520 SUS304, 4 pcs.
(Code No.: 001-336-820)
For NavNet3D MFD12.
(For TZTL12F)
OP19-17 001-337-450 F Mount Panel 15 (Code
No.: 100-397-600-10),
520 SUS304, 4 pcs.
(Code No.: 001-336-820)
TZTL15F Front Fixing Panel Kit.
(For TZTL15F)
Wing bolt
Wing nut
Flush mounting fixture
Protector for screw
Mounting panel
TZTL
unit
TZTL
unit
Hex bolt Hex bolt
TZTL unit
TZTL unit
Frontmount panel
C
o
nso
l
e
c
u
t
o
u
tC
o
nsole cu
t
o
u
t
Self-tapping
SUS304 screws