FUTABA 10CAP - Adjusting the length of the non-slip control sticks; Stick lever tension adjustment; Adjusting Display Contrast

16
Adjusting the length of the non-slip control sticks
<RXPD\DGMXVWWKHWHQVLRQRI\RXUVWLFNVWRSURYLGHWKHIHHOWKDW\RXSUHIHUIRUÀ\LQJ7RDGMXVW\RXUVSULQJV\RX¶OOKDYH
to remove the rear case of the transmitter. First, remove the battery cover on the rear of the transmitter. Next, unplug the
battery wire, and remove the battery and RF module from the transmitter. While you are removing the RF module, pay
attention to the location of the pins that plug into the back of the module. Next, using a screwdriver, remove the four
screws that hold the transmitter’s rear cover in position, and put them in a safe place. Gently ease off the transmitter’s rear
FRYHU1RZ\RX¶OOVHHWKHYLHZVKRZQLQWKH¿JXUHDERYH
Using a small Phillips screwdriver, rotate the adjusting screw for each stick for the desired spring tension. The tension
increases when the adjusting screw is turned clockwise.
:KHQ\RXDUHVDWLV¿HGZLWKWKHVSULQJWHQVLRQVUHDWWDFKWKHWUDQVPLWWHUVUHDUFRYHU&KHFNWKDWWKHXSSHUSULQWHGFLUFXLW
board is on its locating pins, then very carefully reinstall the rear cover being mindful to guide the RF module connector
pins through the slot in the case. When the cover is properly in place, reinstall and tighten the four screws. Reinstall the
battery, cover and module.
Adjusting Display Contrast:
To adjust the display contrast, from the home menu press and hold the END BUTTON.
Turn the DIAL while still holding the END BUTTON:
clockwise to brighten
counterclockwise to darken the display
Let go off the DIALand the BUTTON.
You may change the length of the control sticks to make your transmitter more
comfortable to hold and operate. To lengthen or shorten your transmitter’s
VWLFNV¿UVWXQORFNWKHVWLFNWLSE\KROGLQJORFNLQJSLHFH%DQGWXUQLQJVWLFNWLS
A counterclockwise. Next, move the locking piece B up or down (to lengthen
or shorten). When the length feels comfortable, lock the position by turning
locking piece B counterclockwise.
Stick tip A Locking piece B
Stick lever tension adjustment
Mode 2 transmitter with rear cover removed.
Aileron
Elevator
Rudde
r
Stick Stick