FUTABA 10CAP - Engine idle management: IDLE-DOWN and THR-CUT

40
Engine idle management:
IDLE-DOWN
and
THR-CUT
: functions which work with the digital THROTTLE TRIM to provide
a simple, consistent means of engine operation. No more fussing with getting trim in just the right spot for landings or take
offs! For additional engine adjustments, see
THROTTLE-NEEDLE
(p. 65) and
THROTTLE DELAY
(p. 66).
IDLE-DOWN
(
ACRO
only): lowers the engine idle for: sitting on the runway prior to take off, stalls and spins, and landings.
7KHQRUPDOLGOHVHWWLQJLVDOLWWOHKLJKHUIRUHDVLHUVWDUWVDQGVDIHÀLJKWVZLWKOHVVULVNRIGHDGVWLFNV
Important note: The
IDLE-DOWN
function is not normally used when starting the
engine, and its accidental operation may keep your engine from starting. The
10C warns that
IDLE-DOWN
is on when the transmitter is turned on. Be sure to
turn off the function, or override the warning by pressing CURSOR lever if you
intended the function to be on.
7KLVPD\EHDVVLJQHGWRDQ\VZLWFKSRVLWLRQ6RPHPRGHOHUVDFFLGHQWDOO\DVVLJQ
IDLE-DOWN
to one side of a switch
and
THR-CUT
to the other. There is no “normal” setting to start the engine. By default
IDLE-DOWN
is set to SWITCH C
center and down. This works well with
THR-CUT
also on SWITCH CGRZQ7KH6:,7&+XSLVQRUPDOÀLJKWVWDUWLQJ
FHQWHUIRUVORZHUPDQHXYHUVODQGLQJDQGGRZQWRFXWWKHHQJLQH,I\RXDVVLJQ
IDLE-DOWN
or
THR-CUT
to the spring-
loaded
TRAINER
SWITCH F (10CA) or H (10CH), then use the trainer function, you may risk loss of throttle control
or deadstick for your student.
GOAL of EXAMPLE: STEPS: INPUTS:
Decrease the throttle setting at idle
with the flip of a switch for spins and
landings.
Open
BASIC
menu, then open
IDLE-DOWN
function.
for 1 second.
(If
ADVANCE
, again.)
C
to
IDLE-DOWN
.
Activate the function.
C
to
MIX
. to
OFF
.
With THROTTLE STICK at idle,
adjustthe rate until engine idles as
desired.*
THROTTLE STICK.
C
to
RATE
. until engine idles as
desired.
Optional: change switch assignment.
Choose desired switch and position.**
C
to
SW
. to desired SWITCH.
C
to
POSI
. to desired position.
Close.
Where next?
THR-CUT
: see p. 41.
*Normally a value of 10- 20%. Secure the fuselage, engine running. Set the THROTTLE STICK to idle. Adjust the
IDLE-DOWN
UDWHZKLOHÀLSSLQJWKH
switch ON and OFF until the desired idle is achieved. Be sure to throttle up periodically to allow the engine to “clean out” and idle reliably.
*Also LOGIC SW(Lsw1 to 3) may be assigned. Set up
LOGIC SW
: See p. 38.