FUTABA 10CAP - Page 60

60
GOAL of EXAMPLE: STEPS: INPUTS:
Activate
SNAP-ROLL
. Adjust
elevatortravel to
55%
, rudder travel to
120%
LQWKHULJKWXSVQDS$FWLYDWH
SAFE-MOD
so snaps can not be performed
when gear is down.
$GMXVWUXGGHUWUDYHOLQWKHOHIWGRZQ
snap to
105%
.
(Note: using negative percents can
change any of the 4 snap directions. For
example, change snap 1 to "down" by
changing the elevator percent to
-100%
.)
Open the
SNAP-ROLL
function.
for 1 second.
(If
BASIC
, again.)
C
to
SNAP-ROLL
.
Activate the function.
C
to
MIX
. to
OFF
or
ON
.
Adjust the travels as needed. (Ex:
elevator to
55%
, rudder to
120%
.)
C
to
ELEV
. to
55%
.
C
to
RUDD
. to
120%
.
Optional: Activate
SAFE-MOD
. [Ex: ON
when SWITCH E (10CA) or G (10CH)
is down, meaning snap function is
deactivated when that switch is in the
down position.]
E or G up.
C
to
SAFE-MODE
to
ON
.
snap switch.
Notice
MIX
reading is still
OFF
.
E or G down.
Notice
MIX
reading changes to
ON
.
Optional: Assign switches to up/down
and left/right. (Ex: Change to the left/
down snap and adjust rudder to
105%
.)
C
to
SW1
. to A.
C
to
SW2
. to B.
A down B down.
Repeat steps above to set percentages.
Close menu.
Where next? Set up programmable mixes: see p. 61.
View additional setups on the internet:www.futaba-rc.com\faq\.