13
Before Using
- Digital trim: Steering trim, Throttle trim, Steering D/R
The current position is displayed on the LCD screen for about three seconds when
each digital trim is operated.
- Function select lever function (FNC-DT1/DT2/DT3/DT4)
This function assigns a function to levers (digital trims, grip levers). Trim positioning
at each model call is unnecessary because all the levers are digital.
- Function select switch function (FNC-SW1/SW2)
This function assigns a function to the two installed switches.
- Condition 2 Selection
In specific functions, two rates can be set up, and switched with SW1 switch simulta-
neously during a run.
- NEW design considers operability and weight balance
- Tension adjustment function
The wheel tension can be adjusted from the outside.
- Trigger stopper function (Mechanical ATL)
- High luminosity blue LED pilot lamp
You can select your desired brightness of the pilot lamp. (Four steps)
To Next Page
Loading...
