FUTABA GY601 - T8 Usuper Gyro Mixing Setting Example

27
DATA SETTING
85%
15%
70%
30%
70% 40%
（NORM）（IDL1）（IDL2）
(Setting Example)
Adjust the gyro gain at each the Idle-Up swtch position at the Gyro Mixing
setup screen. The following shows a setting example in the CMT mode.
Select the “ON”
mode.
Select the Idle-Up
switch(SW-E).
Switch position
Sensitivity rate
Set the “NORM”, “IDL1” and “IDL2” gains at each setup screen.
Use the following values as the sensitivity setting standard:
AVCS mode
When set over 50%, the GY601 operates in the AVCS mode and when
set under 50%, the GY601 operates in the Normal mode.
Actual gain
Hovering
Flight
Normal mode
SW-E