FUTABA T26SZ - Page 105

105
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Taphereandgotothe
Servo2settingspage.
(Displayandsettings
contentisthesameas
Servo1.)
WhentheAlarmor
Vibratoroptions
areactivated,the
servoconnectionwill
display.
*ThisalarmanddisplayislimitedtotheS.BUS
servosconnectedtotheservosensors.
Tappingthiswill
takeyoutothe
settingsscreenfor
thecurrentalarm
ŷƈƏƈƐƈƗƕƜŃŝŃŶƈƕƙƒŃƖƈƑƖƒƕŃžŦƘƕƕƈƑƗƀ
7KH6%66FDQPRQLWRUDQGGLVSOD\WKHLQÀLJKW
current, operating angle, and internal temperature
of up to two S.BUS2 servos.
If you forget to connect the servo wiring during
fuselage assembly, or the servo was disconnected,
an alarm can be activated at the transmitter.
*Servosensormustbeinstalledintheaircraft.
●
Select [Servo sensor] in the Telemetry screen
and access the setup screen shown below.
Max.andmin.values
sincethepowerwas
turnedONwilldisplay.
Setsthecurrenton
whichthealarm
operates.
Alarmischosenfrom
Buzzer,Voice,and
Inhibit.
AllowsSpeechtobe
turnedONorOFF.
Vibratorischoicesare
type1-3,andInhibit.
↑Anupwardarrow
indicatesthealarmwill
soundwhenthecurrent
reachesaboveyourset
value.
↓Adownwardarrow
indicatesthealarmwill
soundwhenthecurrent
reachesbelowyourset
value.
Initialvalue:↑ 10.0A↓ 0.0A
Adjustmentrange0.0A~10.0A
( ↑ Limit≧↓ Limit)
●
Return to Linkage menu
Tappingthisandselecting
"Buzzer"willcausethedeviceto
soundanalarmwhenservosare
notconnected.
Tappingthisandselecting"Each
type"willcausethedeviceto
vibratewhenservosarenot
connected.