FUTABA T26SZ - Page 117

117
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
3. Select the operating mode for each channel.
"NORM": The model is controlled by signals from
the student transmitter.
"MIX" mode: The model is controlled by signals from
the teacher and student transmitters. (Reset the
student's model data to the default condition.)
"FUNC" mode (function mode):
The model is controlled by signals from
the student transmitter with the teacher
AFR setting. (Reset the student's model data to the
default condition.)
"OFF": Only the teacher side operates.
*The setting above allows setting of the servo throw relative
to the amount of student side operation when [MIX] or
[FUNC] was selected.
When changing the rate, use the
"▼▼""▼""
▲""▲ ▲"
button to Tap the [Rate] item of the
channel.
 6HWWLQJUDQJHa
Initial value:100
*When the value is tapped, the rate is reset to the initial value.
4. Set the switch of each channel.
*When setting the switch at each channel, tap to the "SW"
item of the channel you want to change, call the switch
setup screen, and select the switch.
"--" : Always ON.
 6$a6+7KHVZLWFKZKLFKHQDEOHVVWXGHQWVLGH
operation can be selected. (See "Switch selection
method" at the end of this manual for selection
method details.)
ŷƕƄƌƑƈƕŃƖƗƘƇƈƑƗŃƆƋƄƑƑƈƏŃƖƈƗƗƌƑƊŃ
ƉƘƑƆƗƌƒƑ
In training mode, the instructor's transmitter can
pick up the student's signal on both the "Function"
and "Mix" channels. That makes it easy for the
two transmitters to connect even if the student and
LQVWUXFWRUKDYHVHWXSWKHLUWUDQVPLWWHUVGL൵HUHQWO\
*When the instructor's transmitter mode is set to "NORM",
the signal of the same channel of the student's transmitter is
output as is. (The same as before.)
Futabaisnotresponsiblefordamage
sustainedbycombinationwithpartsother
thanFutabaGenuineequipment.
WhenconnectingFutabatransmittersto
thetrainercode,donotoperatethepower
switchonthestudentsidetransmitterand
operatethepowerswitchontheteacher
sidetransmitterasbefore.Thestudentside
transmitterturnspowerautomaticallyin
conjunctionwiththeteacherside.
ŷƕƄƌƑƈƕŃƆƒƑƑƈƆƗƒƕŃƓƒƚƈƕŃƖƘƓƓƏƜŃ
ƖƓƈƆƌƲƆƄƗƌƒƑ
Trainer connector to supply power to external
equipment connected to the trainer connector, when
turning on the power by pressing the power switch
in the trainer student mode.