FUTABA T26SZ - Page 140

140
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Elevator → Camber
Elevator → Camber
Elevator → Camber
ŨƏƈƙƄƗƒƕ ڀ ŦƄƐƅƈƕ
[Corresponding model type]: Airplane/glider, 2 ailerons or more
This function is used when you want to mix the
FDPEHUÀDSVZLWKHOHYDWRURSHUDWLRQ:KHQXVHG
WKHÀDSVDUHORZHUHGE\XSHOHYDWRUDQGOLIWFDQ
be increased.
1RWH7DLOOHVVZLQJHOHYDWRUFDQEHRSHUDWHG
ZKHQWKLVPL[LVDFWLYDWHG
ŏ$PL[LQJFXUYHFDQEHVHW
ŏ0L[LQJGXULQJÁLJKWFDQEHWXUQHG212))E\
setting a switch. (Always ON at [--] setting)
ŏ7KHPL[LQJUDWHFDQEHÀQHWXQHGE\VHWWLQJD95
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
●
Tap [INH].
(ON is displayed.)
●
When setting a switch, tap the [--] item of the
switch and tap the screen to call the selection
screen, and then select the switch and set its ON
direction. (Always ON at "--" setting)
(For a description of the switch selection method,
see the description at the back of this manual.)
●
When setting a VR, tap the Fine tuning "--" item
and tap the screen to call the selection screen,
and then select the VR. The adjustment rate can
be set.
The VR operation mode can also be selected.
●
A mixing curve can also be set.
(For a description of the curve setting method, see
the description at the back of this manual.)
●
6HOHFW>(OHYDWRUń&DPEHU@DWWKHPRGHO
menu and call the setup screen shown below.
Currentlyselectedconditionname
● Mixingcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionatthebackof
thismanual.)
Aileronsandflapsrate
adjustment
Overalladjustmentby
RateAandRateB.
Conditiongroup/single
modeselection(Gr./Sngl)
TheON/OFFswitchof
mixingischosen.
FinetuningVRsetting
Operationmode
Adjustmentrate
Activatethefunctionby
tappingthe[INH].
●
Return to Model menu
Thevalueinsidethe
parenthesesshowsthe
currentrudderposition.