FUTABA T26SZ - Page 141

141
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Currentlyselectedconditionname
● Mixingcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionatthebackof
thismanual.)
Ailerons,flapsand
elevatorsrateadjustment
Overalladjustmentby
RateAandRateB.
Conditiongroup/single
modeselection(Gr./Sngl)
TheON/OFFswitchof
mixingischosen.
Activatethefunctionby
tappingthe[INH].
ŦƄƐƅƈƕŃƐƌƛƌƑƊ
[Corresponding model type]: Airplane/glider, 2 ailerons or more
This function adjusts the rate of camber operation
which operates the wing camber (ailerons, camber
flaps, brake flaps) in the negative and positive
directions. The aileron, flap, and elevator rates
can also be adjusted independently by curve, and
attitude changes caused by camber operation can
be corrected.
*Initial setting assigns camber operation to side lever LS.
ŏ7KHXSGRZQVLGHUDWHVRIWKHDLOHURQÁDSDQG
elevator servos can be adjusted by curve. When
the mixing direction is reversed by the linkage,
adjustments can be made by changing the
PL[LQJUDWHSRODULW\RU
ŏ0L[LQJGXULQJÁLJKWFDQEHWXUQHG212))E\
setting a switch. (Always ON at [--] setting)
ŏ$GHOD\FDQEHVHWIRUHDFKFRQGLWLRQ$FXW
switch which can turn OFF the delay function can
be set.
ŏ7KHVSHHGRIWKHDLOHURQÁDSDQGHOHYDWRUVHUYRV
can be set. (In side/Out side)
Servospeedsetting
(Foradescriptionofthe
settingmethod,seethe
descriptionatthebackof
thismanual.)
●
Select [Camber mixing] at the model
menu and call the setup screen shown
below.
Conditiondelaycut
switch
Conditiondelaysetting
●
Return to Model menu