FUTABA T26SZ - Page 142

142
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
AIL3
(ChipAileron)
AIL4
(ChipAileron)
AIL1
(MainAileron)
AIL2
(MainAileron)
FLP2
(CamberFlap)
FLP1
(CamberFlap)
ELEVATOR
ELEVATOR2
V-TAIL
ELEVATOR
ELEVATOR2
AILVATOR
FLP3
(BrakeFlap)
FLP4
(BrakeFlap)
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
●
Tap [INH].
(ON is displayed.)
●
When setting a switch, tap to the [--] item of the
switch and tap the screen to call the selection
screen, and then select the switch and set its ON
direction. (Always ON at "--" setting)
(For a description of the switch selection method,
see the description at the back of this manual.)
●
When setting a condition delay, tap to the
[Condition delay] item.
Set the delay.
When setting a cut switch, tap [Cut-switch] and
tap the screen to call the selection screen, and
then select the switch and set its ON direction.
(Always ON at [--] setting)
(For a description of the condition delay function,
see the description at the back of this manual.)
(Curve/rate setup screen)
●
The curve and rate are adjusted by calling the
DLOHURQÁDSDQGHOHYDWRUFXUYHUDWHVFUHHQV
The rate and curve of each servo can be set by
calling each screen. (For a description of the curve
setting method, see the description at the back of
this manual.)
The servo speed can also be adjusted.
LS