FUTABA T26SZ - Page 143

143
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ELEVATOR
ELEVATOR2
AILVATOR
AIRBRAKE
V-TAIL
ELEVATOR ELEVATOR2
ŤƌƕƅƕƄƎƈ ڀŃŨůŨ
[Corresponding model type]:
Airplane/glider, general
This mix is used when you want to mix the
elevators with airbrake (spoiler) operation. It
raises the elevators to correct for dropping of the
nose during airbrake operation.
*This function does not operate when airbrake is not assigned
at the Function menu in the Linkage menu.
ŏ7KH5DWHVLGH5DWHVLGHPL[LQJUDWHZLWKWKH
elevator servos can be adjusted.
ŏ$PL[LQJFXUYHFDQEHVHW
ŏ0L[LQJGXULQJÁLJKWFDQEHWXUQHG212))E\
setting a switch. (Always ON at [--] setting)
ŏ7KHPL[LQJUDWHFDQEHÀQHWXQHGE\VHWWLQJD95
●
Select [Airbrake
→
ELE] at the model menu
and call the setup screen shown below.
*The display screen is an example. The actual
screen depends on the model type.
Adjustmentof
elevatorservo
Currentlyselectedconditionname
● Mixingcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionatthebackof
thismanual.)
Up/Downoverall
adjustmentatRateA
andRateB
Activatethefunctionby
tappingthe[INH].
Conditiongroup/single
modeselection(Gr./Sngl)
TheON/OFFswitchof
mixingischosen.
Finetuning
setting
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
●
Tap [INH].
(ON is displayed.)
●
When setting a switch, tap the [--] item of the
switch and tap the screen to call the selection
screen, and then select the switch and set its ON
direction. (Always ON at "--" setting)
(For a description of the switch selection method,
see the description at the back of this manual.
●
When setting a VR, tap the Fine tuning "--" item
and tap the screen to call the selection screen,
and then select the VR. The adjustment rate can
be set. The VR operation mode can also be set.
(For a description of the fine tuning VR setting
method, see the description at the back of this
manual.)
●
A mixing curve can be set.
(For a description of the curve setting method, see
the description at the back of this manual.)
●
Return to Model menu