145
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
RUDDER2
RUDDER
RUDDER
V-TAIL
RUDDER2
Winglet
RUDDER1
Winglet
atFlyingwing
atFlyingwing
() ()
AIL3
AIL3
(ChipAileron)
(ChipAileron)
AIL1
(MainAileron)
AIL2
(MainAileron)
ŵƘƇƇƈƕ ڀŃŤƌƏƈƕƒƑ
[Corresponding model type]:
Airplane/glider, general
This function is used when you want to mix the
ailerons with rudder operation. It is used when
rudder is applied during roll maneuvers, knife
edge, etc. of acrobatic planes. It can be used to
bank scale models, large models, etc. like a full
size plane.
ŏ$PL[LQJFXUYHFDQEHVHW
ŏ0L[LQJGXULQJÁLJKWFDQEHWXUQHG212))E\
setting a switch. (Always ON at [--] setting)
ŏ/LQNLQJFDQEHVHW/LQNWKLVPL[WRRWKHUPL[HV
ŏ7KHPL[LQJUDWHFDQEHÀQHWXQHGE\VHWWLQJD95
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
ŏ7DS>,1+@
(ON is displayed.)
ŏ:KHQVHWWLQJDVZLWFKWDSWRWKH>@LWHPRIWKH
switch and tap the screen to call the selection
screen. Then, select the switch and set its ON
direction. (Always ON at "--" setting)
(For a description of the switch selection method,
see back of this manual.)
ŏ:KHQVHWWLQJD95WDSWRWKH)LQHWXQLQJLWHP
and tap the screen to call the selection screen
and then select the VR. The adjustment rate can
be set.
The VR operation mode can also be set.
(For a description of the fine tuning VR setting
method, see the description at the back of this
manual.)
ŏ$PL[LQJFXUYHFDQEHVHW
(For a description of the curve setting method, see
the back of this manual.)
ŏ:KHQOLQNLQJWDSWKH>/LQN@LWHP21LVGLVSOD\HG
Currentlyselectedconditionname
● Mixingcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionatthebackof
thismanual.)
Left/rightoverall
adjustmentatRateA
andRateB
Activatethefunctionby
tappingthe[INH].
Conditiongroup/single
modeselection(Gr./Sngl)
TheON/OFFswitchof
mixingischosen.
Finetuning
setting
ŏ6HOHFW>5XGGHUń$LOHURQ@DWWKHPRGHOPHQXDQG
call the setup screen shown below.
Tosetlinking,taptothe
[OFF]item
ŏ5HWXUQWR0RGHOPHQX