FUTABA T26SZ - Page 146

146
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
ŏ7DS>,1+@
(ON is displayed.)
ŏ:KHQVHWWLQJDVZLWFKWDSWRWKH>@LWHPRIWKH
switch and tap the screen to call the selection
screen. Then, select the switch and set its ON
direction. (Always ON at "--" setting)
(For a description of the switch selection method,
see the description at the back of this manual.)
ŏ:KHQVHWWLQJD95WDSWKH)LQHWXQLQJLWHPDQG
tap the screen to call the selection screen and
then select the VR. The adjustment rate can be
set.
The VR operation mode can also be set.
(For a description of the fine tuning VR setting
method, see the description at the back of this
manual.)
ŏ$PL[LQJFXUYHFDQEHVHW
(For a description of the curve setting method, see
the description at the back of this manual.)
ŏ:KHQOLQNLQJWDSWKH>/LQN@LWHP21LVGLVSOD\HG
Currentlyselectedconditionname
● Mixingcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionatthebackof
thismanual.)
Up/Downoverall
adjustmentatRateA
andRateB
Activatethefunctionby
tappingthe[INH].
Conditiongroup/single
modeselection(Gr./Sngl)
TheON/OFFswitchof
mixingischosen.
Finetuning
setting
Tosetlinking,taptothe
[OFF]item
ŵƘƇƇƈƕ ڀ ŨƏƈƙƄƗƒƕ
[Corresponding model type]: Airplane, general
This function is used when you want to mix
elevator operation with rudder operation. It is used
to correct undesirable tendencies when rudder
is applied in roll maneuvers, knife edge, etc. of
acrobatic planes.
ŏ$PL[LQJFXUYHFDQEHVHW
ŏ0L[LQJGXULQJÁLJKWFDQEHWXUQHG212))E\
setting a switch. (Always ON at [--] setting)
ŏ/LQNFDQEHVHW/LQNVWKLVPL[LQJWRRWKHUPL[LQJV
ŏ7KHPL[LQJUDWHFDQEHÀQHWXQHGE\VHWWLQJD95
(Fine tuning)
ŏ6HOHFW>5XGGHUń(OHYDWRU@DWWKHPRGHO
menu and call the setup screen shown
below.
ŏ5HWXUQWR0RGHOPHQX