FUTABA T26SZ - Page 147

147
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ťƘƗƗƈƕƳƜ
[Corresponding model type]: Glider, 2 ailerons or more
This function allows powerful brake operation by
simultaneously raising the left and right ailerons
DQGORZHULQJWKHÀDSVFDPEHUÀDSEUDNHÀDS
This setting will allow the ailerons to be raised
while the flaps are simultaneously lowered.
Butterfly (crow) produces an extremely efficient
landing configuration by accomplishing the
following:
1. Slow the aircraft’s velocity.
2. Provide washout at the wing tips to reduce the
tendency to tip stall.
3. Create more lift toward the center of the wing
DOORZLQJLWWRÁ\DWDVORZHUVSHHG
ŏ0L[LQJGXULQJÁLJKWFDQEHWXUQHG212))E\
setting a switch. (Always ON at [--] setting)
ŏ7KHEXWWHUÁ\RSHUDWLRQUHIHUHQFHSRLQWFDQEH
offset. When the screen is tapped with the offset
item selected when operated to the position to
be changed, the reference point is offset. If the
reference point is offset too much, unexpected
operation may be performed.
ŏ7KHDLOHURQVDQGÁDSVRSHUDWLRQVSHHGFDQEH
adjusted. (In side/Out side)
ŏ$GHOD\FDQEHVHWIRUHDFKFRQGLWLRQ$FXW
switch which can turn OFF the delay function can
also be set.
ŏ7KHGLIIHUHQWLDOUDWHFDQEHDGMXVWHG
*When servo binding occurs when setting the ailerons and
ÀDSVLQEXWWHUÀ\PL[LQJXVHWKH$)5IXQFWLRQWRDGMXVWWKH
rate.
ŏ6HOHFW>%XWWHUIO\@DWWKHPRGHOPHQX
and call the setup screen shown
below.
*The display screen is an example. The actual
screen depends on the model type.
Whenusingthis
function,Tap[INH].(ON
isdisplayed.)
Conditiongroup/single
modeselection(Gr./Sngl)
TheON/OFFswitchof
mixingischosen.
Conditiondelaysetting
Conditiondelaycut
switch
Tonextpage
Thedifferentialrate
canbeadjusted.
Inspeed
Outspeed
（First）0 〜 27（Slowly）
（First）0 〜 27（Slowly）
*Thedisplayscreenisanexample.Theactual
screendependsontheModelType.
Whenoffsettingthebutterflyoperation
referencepoint,operatetothethrottle
stickpointyouwanttochangeandthen
touchtheOffsetbutton.Thereferencepoint
displays0%.When[Yes]istouched,the
referencepointischanged.Then,"Initialize
elevatorcurve?"appears,allowingyouto
confirmyoursetting.
:KHQGL൵HUHQWLDOUDWHLVWKHFDOFXODWLRQPHWKRGRI83
DOWN and a direction become reverse.
:KHQGL൵HUHQWLDOUDWHLV8SUDWHLVGHFUHDVHDQG'2:1
rate is increase.