FUTABA T26SZ - Page 167

167
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
GyrosettingGYA553
Config
Config
Config 6/9 HoldingPower
C1-C5switch
button
Withtheswitchbutton,the
"holdingpower"ofeachrate(C1to
C5)canbedisplayedandadjusted.
C1 C5
-100% 100%-35% 35%0%
C1 C3 C5C4C2
-100% 100%-25%-75% 75%25%0%
-100%
100%
0%
The current rate numbers C1 to C5 are displayed by operating the channel of the transmitter.
/LNH WKH ÀLJKW FRQGLWLRQ IXQFWLRQ RI WKH WUDQVPLWWHU \RX FDQ VHW XS WR  GL൵HUHQW GDWD IRU WKH DWWLWXGH
holding force rate of the aircraft in AVCS mode by operating the switch from the transmitter, and switch
between them. You can set the holding power rate selector switch to the channel with the AFR function of
the transmitter, and set the point for each rate on the AFR point curve to switch. It is also possible to use
WKHÀLJKWFRQGLWLRQIXQFWLRQWRZRUNZLWKWKHÀLJKWFRQGLWLRQVZLWFK
WhensettoSWofDG1orDG2
Switchchannelrate
Channelrate
C1
C5
S.BUSBasic2/4Config6/9
Displayandadjustthecurrent
ratenumbersC1toC5by
operatingthechannelonthe
transmitter.
Byoperatingthechannelofthe
transmitter,thechannelposition
ofthecurrentratenumbersC1
toC5willbedisplayedingreen.
It is a function to adjust the posture holding force of the aircraft in AVCS mode.
Decreasing the value weakens the holding power and makes the operation feeling closer to the normal
mode.
Whensettodialorlever