FUTABA T26SZ - Page 168

168
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
GyrosettingGYA553
Config
Config
Config
7/9 4DFlight(Backwardflight)GyroReverseModeAdjustment
Config
8/9 4DFlight(Backwardflight)ModeAdjustment
3DJHLVIRUVHWWLQJWKHJ\URUHYHUVHPRGH7KLVLVDVSHFLDOVHWWLQJIRU'EDFNZDUGÀLJKW6HOHFWZKHWKHU
WRUHYHUVHWKHFRQWUROGLUHFWLRQRIWKHDLOHURQHOHYDWRUDQGUXGGHUZKHQÀ\LQJEDFNZDUG1RUPDOO\ZKHQ
À\LQJEDFNZDUGWKHVWHHULQJGLUHFWLRQRIDOOWKHUXGGHULVUHYHUVHGVRWKHFRQWUROGLUHFWLRQRIWKHJ\URLV
also reversed.
Switching between forward (FW) and reverse (BK) uses the same CH12 signal as the holding force. Up from near the midpoint of the throttle stick is
forward, and down is reverse.
For details on setting the switching point, please refer to the transmitter settings.
In gyro reverse mode, the gyro controls in the same direction as the aircraft’s tilt. Switch between forward and reverse to check that the gyro control
direction changes correctly.
3DJHLVIRUVHWWLQJWKHJ\URUHYHUVHPRGH7KLVLVDVSHFLDOVHWWLQJIRU'EDFNZDUGÀLJKW
7KH$(7%.DQG$(7):IXQFWLRQVHVWLPDWHWKHDLUFUDIW¶VÀLJKWDWWLWXGHGXULQJIRUZDUGDQGEDFNZDUGWUDQVLWLRQVDQGRSWLPL]HJ\URFRQWURO,I
the aircraft’s attitude changes quickly, decrease the value. If the attitude changes slowly, increase the value. The correction values for forward and
backward transitions can be set independently. The setting range is 0 to 30. The OPC parameter adjusts the speed when the control amount increases
and decreases. The setting range is 0 to 27. The values in the setting example are the standard setting values for SkyLeaf-ST. The optimal value will
YDU\GHSHQGLQJRQWKHDLUFUDIWFKDUDFWHULVWLFVDQGÀLJKWVW\OH
Config 9/9 Reset
Reset each Config item. It returns to the initial
value.
S.BUSBasic3/4Config7/9